Ducati Pro-I Evo Black Edition, User Manual

Page: 19 / 368

18
CAUTION
Zero Start Function: the accelerator is activated once the forward speed exceeds 3 km/h. For safety reasons, the item is initially
set up to avoid standing starts.
• When riding the item, tilt the body in the riding direction during a turn and slowly turn the handlebars.
• To stop the item, release the accelerator, pull the brake lever.
• To get off, first stop the item completely. Getting off the moving item can cause injury.
• Prior to each use, check brakes and any wear, check tyre pressure (see side of tyre for recommended value), wheel wear,
accelerator and charge status of battery.
Brake lever adjustment
Brake levers
Refer to point A (see photo) to adjust the position of the brake lever, if
necessary.
Regolazione dei freni
Adjusting the brake calliper
If the brake is too tight or too loose, use the hex
wrench to loosen the nut (A), then adjust the brake
cable, (shorten the brake cable at the top if it is too
tight; if it is too loose, pull the brake cable downwards)
and then, retighten the nut (A). If the wire is too loose
or too tight even after following the first step, it may
be necessary to adjust the (fixed) brake pad by means
of the wheel located on the opposite side; use the hex
wrench to move the brake pad (B) closer or further
away (see picture).
Check the correct alignment between the brake caliper
and the disc. Use screws C and D to adjust the position
/ alignment on the disc, if necessary.