Clutch unit: APTC wet clutch
Caution
Keep the plates in the same order as originally fitted. You may find it convenient to tie the plates together while
putting them on the bench.
Checking and overhauling the APTC unit
Clearance between clutch housing and drive plate
Insert the drive plate (A) in the clutch housing (B) and measure clearance (S) with a feeler gauge.
The clearance "S" must not exceed
0.6
mm.
If it does, change the plates and, if necessary, the clutch housing.
Overhauling the clutch plates
The clutch plates must not show any signs of blackening, grooves or deformation.
Measure the thickness of the drive plates (friction plates). It should not be less than
3.2
mm.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_6A9_00.67.1.html (6 of 12) [10/7/2008 8:45:55 PM]