Ducar D2000iS, Operator'S Manual

Page: 9 / 27

9
AC Pilot Indicator Light
The green AC Pilot Indicator Light comes on when the
engine starts and generates power.
CONTROL PANEL FUNCTIONS
Oil Warning
Indicator
Overload
Indicator
AC Pilot
Indicator
DC Circuit Breaker
When the DC Circuit Breaker is in the “ON” position, the generator is able to supply power to connected electronic devices.
When the DC Circuit Breaker is in the “OFF” position, the generator will no longer supply power. The DC Circuit Breaker
automatically turns “OFF” when connecting electronic devices to the generator that exceed the generator’s rated output. If
the DC Circuit Breaker turns off, reduce the load of connected electronic devices until the load is within the specified rated
output. To re-establish power, return the DC Circuit Breaker back to the “ON” position.
CAUTION!
If the DC Circuit Breaker turns off again, stop using the generator immediately and consult our
dealers.
Engine ECO Control
• When the Engine ECO switch is turned to the “ON” position, the economy control unit automatically determines the
generator’s proper engine speed based on the connected electronic load. This results in superior fuel economy and
reduces noise.
• When the ECO switch is turned to the “OFF” position, the engine runs at the rated speed of 4,850 r/min.
Note:
The ECO switch must be turned to the “OFF” position when using electronic devices that require a large starting
current, such as a compressor.
Parallel Outlets
Located just above the Ground Terminal, the generator’s Parallel Outlets enable a user to run two D2000iS generator’s
simultaneously. This operation requires special cables. When operating parallel generators, the rated output is 3.0Kva and
the rated current is 25A/120V. For cables and instructions consult a DUCAR dealer for a PARALLEL OPERATION CABLE
KIT.
• Only connect this generator to another D2000iS Standard Generator or D2000iS Companion Generator
• Only use brands approved parallel operation cable kit to connect generators
WARNING!
Never connect generators that are different models.