DTS MOON 1200, User Manual

Page: 8 / 12

The ambient temperature should not exceed 35°C.
4 A hot lamp may explode, so always wait for at least 10 minutes to elapse after the unit has
been turned off prior to attempting to replace the lamp.
5 Always wear suitable hand protection when handling the lamp.
Level of protection against the penetration of solid and liquid matter
1 The projector is classified as an ordinary appliance and its level of protection against the
penetration of solid and liquid matter is IP 20.
2 The projector contains electric and electronic components which should under no
circumstances come into contact with oil, water or any other liquid. The proper working of the
unit would be compromised should this occur.
MOUNTING THE LAMP
Warning: Remove mains power before opening the unit.
OSRAM: HTI 1200W/D7/60
Power 1200W
Luminous flux 110,000 lm
Colour temperature 6000°K
Lampsocket SFc-10-4
Rated life 1,000 hours
The lamp used is manufactured from quartz glass and should be handled with care. Always
adhere to the instructions supplied in the lamp's packaging. Never touch the glass directly but
use the tissue provided in the lamp's packaging.
REPLACING THE LAMP
Warning: Remove mains power before opening the unit.
Remove the top rear cover by loosing the 2 screws on the back side of the unit panel.
The lamp must be inserted on the lamp socket by passing through the front side of the
aluminium reflector
FORCED VENTILATION
You will note, on inspection, that the fixture features various air inlets and cooling fans located
on both the base and head of the fixture. These should, under no circumstances, be blocked or
obstructed whilst the projector is in operation.
Doing so could cause the fixture to seriously overheat thereby compromising its proper
operation.
The ambient temperature should not exceed 35°C.
4 A hot lamp may explode, so always wait for at least 10 minutes to elapse after the unit has
been turned off prior to attempting to replace the lamp.
5 Always wear suitable hand protection when handling the lamp.
Level of protection against the penetration of solid and liquid matter
1 The projector is classified as an ordinary appliance and its level of protection against the
penetration of solid and liquid matter is IP 20.
2 The projector contains electric and electronic components which should under no
circumstances come into contact with oil, water or any other liquid. The proper working of the
unit would be compromised should this occur.
MOUNTING THE LAMP
Warning: Remove mains power before opening the unit.
OSRAM: HTI 1200W/D7/60
Power 1200W
Luminous flux 110,000 lm
Colour temperature 6000°K
Lampsocket SFc-10-4
Rated life 1,000 hours
The lamp used is manufactured from quartz glass and should be handled with care. Always
adhere to the instructions supplied in the lamp's packaging. Never touch the glass directly but
use the tissue provided in the lamp's packaging.
REPLACING THE LAMP
Warning: Remove mains power before opening the unit.
Remove the top rear cover by loosing the 2 screws on the back side of the unit panel.
The lamp must be inserted on the lamp socket by passing through the front side of the
aluminium reflector
FORCED VENTILATION
You will note, on inspection, that the fixture features various air inlets and cooling fans located
on both the base and head of the fixture. These should, under no circumstances, be blocked or
obstructed whilst the projector is in operation.
Doing so could cause the fixture to seriously overheat thereby compromising its proper
operation.
ENG
ARC 1200
MOON 1200
8