DTS DRIVENET 1664, User Manual, Page: 17 / 47

User Manual
Ver. 1.00 15 di 43
DRIVENET
For installations where long distance DMX cable connections are needed, we suggest to use a DMX
terminator.
The DMX terminator is a male XLR 5-
pins connector with a 120 Ω resistor between pin 2 and pin 3.
The DMX terminator must be plugged in into the last unit’s DMX OUT panel connector of the DMX line.
Place a 120 Ω resistor between pin 2 and 3 of a male XRL
connector;
Plug the resistor into the DMX OUT panel connector of the last unit
connected to the DMX line.
8.2 DMX Modes
DRIVENET 28 EZ can be used in nine different DMX modes: 8 ch (default), 10 ch, 4 ch, 2 ch, 1 ch, 8 ch +
Dimmer, 4 ch + Dimmer, 2 ch + Dimmer or Custom 8 ch.
If you to use the DRIVENET 28 EZ in 8 DMX channels mode, set the following addresses on the mixer:
Device 1 A001
Device 2 A009
If you want to select the next device, just add “8” to the former DMX address
Device 3 A017
….. A….
Device 6 A041
DRIVENET 416 and 416 POWER can be used in eight different DMX modes: 16 ch (default), 32 ch, 10 ch, 14
ch, 40 ch, 56 ch, 24 ch or 1 ch mode.
If you want to use the DRIVENET 416 / 416 POWER in 16 channels mode, select the “
Full type – 8 bit 16ch ”
mode from the DMX MODE menu, under DMX SETUP, and set the following addresses on the mixer:
Device 1 A001
Device 2 A017
If you want to select the next device, just add “16” to the former DMX address
Device 3 A033
….. A….
Device 6 A081
DRIVENET 832 / 832 24Vdc / 832 POWER /832 POWER 24Vdc can be used in eight different DMX modes:
32 ch (default), 64 ch, 10 ch, 14 ch, 112 ch, 80 ch, 48 ch or 1 ch mode.
If you want to use the DRIVENET 832 / 832 24Vdc / 832 POWER / 832 POWER 24Vdc in 32 channels mode,
select the “
Full type – 8 bit 32ch ” mode from the DMX MODE menu, under DMX SETUP, and set the
following addresses on the mixer:
Device 1 A001
Device 2 A033 If you want to select the next device, just add “32” to the former DMX address
Device 3 A065
….. A….
Device 6 A161