DTS ALCHEMY 5, Manual, Page: 7 / 61

RDM – DMX – Manual Ver. 1.08 5 di 58
ALCHEMY 5
e.g., when using the unit in “CCT” (Default) mode (20 DMX channels), set the following addresses on the light
desk:
Projector 1 A001
Projector 2 A021 If you want to select the next projector, just add “20” to the former DMX address
Projector 3 A041
….. A….
Projector 6 A101
1.2 Setting Up the DMX Address
1 Press the UP and DOWN key until you reach the desired DMX address. The numbers on the display will
start flashing (new DMX address hasn't yet been set).
2 Press ENTER to confirm your selection. The numbers on the display will stop flashing; the projector is now
set to the new DMX address.
TIP : if you keep pressed down the UP or DOWN keys, address scrolling will be quicker allowing thus for a
faster selection.
2 Art-Net / sACN Signal Connection
ALCHEMY 5 can be controlled through Art-Net / sACN signals.
Connection between the light controller and the projector must be carried out using a category 5 network cable
and a standard RJ45 connector.
2.1 Direct Ethernet Operation
For direct Ethernet operation, connect the light controller’s Art-Net / s-ACN output signal via Ethernet switch to
each unit’s etherCON RJ45 IN connector.
For each unit, scroll to “NETWORK” menu (refer to the paragraph “Display Function” for further details):

Inside the “INPUT” menu, select “Art-Net” or “sACN” as input control signal.

Inside the “IP ADDRESS MODE” menu, select “Default” or “Static” mode.

Inside the “ETH TO DMX” menu, select ON.

Set the IP address and Net Mask. IP address must be different for each unit on a network.

Set the Art-Net or sACN Universe.