DTM System
spółka z ograniczoną odpowiedzialnością spółka komandytowa
4a
G/LOCK GOES OUT,
C1 LED BLINKS
-MASTER REMOTE ADDED
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
4b
G/LOCK GOES OUT,
C2 LED BLINKS
-MASTER REMOTE DELETED
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
2.8.Service lock.Adding / deleting the "master" remote.
Service lock is a function which switches off operation of remotes added to the receiver at the time of eg. maintenance on the
installation. Enabling service lock cause that receiver does not respond to the signal from the remotes.
To activate service lock it is necessary to add "master" remote to the receiver. Adding "master" remote is independent of
adding remotes to the channels. "Master" remote can be used for control of the channel and for switching the service lock as
well.You can enter up to 5 "master" remotes to activate/deactivate the service lock.
To add/delete a "master" remote pressC1 orC2 button. LEDC1 orC2 and LED indicating the currently selected operating mode
MOM / MONO / BIST will light. By pressing theC1 orC2 button repeatedly light theG/LOCK LED.G/LOCK LED will blink. During
this time, press and hold for 3 seconds remote button. C1 LED blinks if "master" remote added, C2 LED blinks if "master"
remote deleted.
It is recommended that the "master" remote was not added to the receiver and served only to activate/deactivate the
service lock.
2
1
IN RECEIVER RADIO
RANGE
PRESS AND HOLD
FOR 5 SECONDS
TWO REMOTE BUTTONS
4
C1 LED BLINKS
- REMOTE REGISTERING
SUCCESSFUL
Fig.9.
Adding a remote with the use of Galactic function.
REMOTE WITH GALACTIC
CODE
868
433
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
2.7.Adding the remote with the use ofGalactic function (not available for MICRO2 version)
The condition of the success of adding the remote with the use of the Galactic function is the compatibility of authentication
codes set in the receiver and the remote.
In order to add the remote, press and hold for 5 seconds any two buttons on the remote, in receiver radio range.
Failed adding can be caused by:
h
incompatibility of authentication codes in the receiver and transmitter,
h
low battery,
h
radio interference that may occur during the procedure,
h
the receiver memory is full (attempt to add 201 remote).
2
3
1
REPEATEDLY PRESS C1/C2
BUTTON TO LIGHT
G/LOCK LED
G/LOCK LED
WILL BLINK
PRESS AND HOLD
REMOTE BUTTON
FOR 3 SECONDS
868
433
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
3s
Fig.10.
Adding/deleting the „master” remote.
