23
Do not install reflecting mirrors
or screens in the operating area
of the photocell, the receiver
should be mounted on the less sunny side,
do not install the photocell receiver in the
environment with a lighting of foreign light,
especially coming from fluorescent lights,
as this may interfere with the barrier. Be
careful not to contaminate the optical
elements of the transmitter / receiver.
After the mechanical installation an electrical
connection should be done. The connection
should be carried out in accordance with an
exemplary diagram shown in Figure 8, and
according to the following description:
•
connect control output of photocell
receiver to the correct input in the gate
controller. Pay special attention to the
control mode (NC or NO) required in the
control board unit. The standard solution of
optical sensors operating mode in the gate
automation is the NC configuration;
•
if you intend to use the battery-saving
function, connect the power of the
photocell receiver to the photo-test output
of gate controller. Every time the power is
off, transmitter switches to the FAST mode
for 90s. If you can not use the output of
photo-test, you can connect photocell
receiver input T to the output of the positive
polarity, which runs during the gate
movement, for example flashing lamp. If
the output is OC (open collector), where the
potential is minus, connect resistor
8,2KΩ between the input T and the positive
power potential;
•
put the battery in the transmitter (note the
correct polarity));
•
connect the power supply to the
corresponding screw terminals of the
receiver;
Fig.7.
Spacing of holes in the scale of 1: 1,
with the assembly drawing.
1. splash-proof external cover
Legend:
20 mm
o
200
USE THIS FIGURE AS A TEMPLATE
126 mm
11 mm
43 mm
10 mm
1
DTM System
spółka z ograniczoną odpowiedzialnością spółka komandytowa
ul. Brzeska 7, 85-145 Bydgoszcz
tel./fax. (52) 340-15-83, 340-15-84
www.dtm.pl, [email protected]
Summary of Contents for SLIMBAT II
Page 27: ...27 ...
