5
1. Introduction
1.1General information
The DTM System electromechanical drive is designed to automate garage doors. The assembled and
launched system can be conveniently operated by radio transmitters (remote controls).
1.2. Technical data
•
power supply
230 VAC / 50Hz
•
current consumption / at rest
1A / 0.04 A
•
protection class
IP-20
•
maximum gate movement speed:
125 mm / s
•
maximum drawbar pull:
800N
•
work intensity
15% (9 cycles / h)
•
temperature range
-20 ° C to + 50 ° C
•
built-in lighting / lighting time
permanent LED / 4min.
•
length of the running rail with drive and handle: 3440 mm, folded from elements, with toothed belt
•
maximum stroke of the trolley:
2650mm
•
maximum door width:
5000 mm
•
maximum door area of
12.6 m2
•
automation control
wall button / radio remote controls
•
input for safety devices
yes, photo input
•
accessories power output:
yes, + 24VDC max. 100mA
•
operating modes:
open, close, step by step, close after time, airing
•
photo input operating modes:
stop, reverse when closing or closing and opening
•
retraction of the trolley after closing:
yes, 1-5mm
1.3 Mechanical components
Before starting work, check if all the elements shown in fig. 1 are present, and then read the entire
manual.
2. MECHANICAL ASSEMBLY
2.1. Verification of the type and structure of the gate
In order to properly complete and install the automation system, verify the type of your gate and check
the structure of the existing or installed gate against the requirements set out below:
Technical data / Introduction
Fig. 1.
Necessary mechanical elements.
4xM6
4xM6
6
2x
2x
6
1
3
10
7
8
11
9
2a
2b
2c
4
5
1
2
3
4
Part definition:
1 drive head with lighting;
2a a C-shaped rail together with a toothed drive belt;
2b "C" shaped rail with holes;
2c "C" shaped rail;
3 slip-on connectors, 2 pieces;
4 carriage and emergency release locking mechanism;
5 remote control transmitter
6 ceiling hanger;
7 pin and securing pin, bolt and tension spring;
8 front piece;
9 a tension element;
10 cart-gate pusher;
11 gate hardware;
