2
SECURITY OF IMPLEMENTATION OF THE AUTOMATION SYSTEM
Before starting the installation, carefully read the entire product installation and operation manual.
Non-observance and non-compliance with the notes in this manual may lead to an accident in which people
are injured or property damage occurs.
The gate drive ensures correct and safe operation only if the installation and use comply with the following
safety rules. DTM System is not responsible for accidents resulting from improper use or unprofessional
installation of devices.
The drive has an electronic obstacle detection mechanism. In order to ensure an adequate level of
safety, the adjustment of the force should be performed with particular care.
·
Do not leave packaging materials within the reach of children, as they are potentially dangerous;
·
This product has been designed and manufactured solely for the intended use described in this
documentation. Using it for any other purpose may adversely affect the technical condition and
operation of the device and is a potential source of danger;
·
DTM System is not responsible for the consequences of improper use, not in accordance with the
intended use;
·
The drive must be operated in a dry room;
·
Do not install the device in an environment with an increased risk of explosion or aggressive air;
·
If possible, install the drive at least 2.1 meters above the ground;
·
If a rail extension is installed on a heavy gate with the drive, use a second ceiling suspension;
·
The half-open gate must remain in this position. If the gate moves up or down, it must be
mechanically adjusted;
·
It is allowed to install the drive moved away from the symmetry axis of the gate if it does not cause
deformation of the gate itself and allows the gate to move properly in the guides;
·
Automatic swing gates should comply with the standards as well as with any applicable local
regulations, they must comply with the requirements of EN 12604;
·
DTM System is not responsible for the consequences of design defects of the driven elements or for
their deformation that may occur during use;
·
The walls and ceilings to which the drive is to be mounted must be strong and stable;
·
The installation must conform to the requirements of EN 12453. The safety level of the C + D
automated system is required;
·
Before starting any work on the system, disconnect all power sources;
·
The electrical installation to which the automation is connected must comply with the applicable
standards and be properly made;
·
The installer should provide the device with a residual current device ensuring that the devices are
cut off from the main power supply. The standards require a separation of the contacts of at least
3mm in each pole (EN 60335-1). It is recommended to use a 6A thermal fuse with a circuit breaker for
all circuits;
·
Take care to protect the power circuit with a differential switch with a threshold of 30mA;
·
Safety mechanisms (EN12978 standard) provide protection against the risks associated with the
movement of moving mechanical parts, such as crushing, snagging or detachment;
·
DTM System is not responsible for the safety and efficient operation of the automation system in
the event of using components that are not products offered by DTM System;
·
Only genuine parts should be used for servicing;
·
Do not modify the automation components in any way;
·
The end user should be informed about the method of handling, dealing with failures and about the
dangers of using the automation system;
·
During the operation of the automation system, both children and adults must keep a safe distance
from the operating automation;
·
The automation system can only be operated by properly trained adults
·
Control devices should be out of the reach of children in order to protect the automation system
against accidental activation;
·
Movement through the gate is allowed only when it is fully open;
·
Service is only permitted by qualified personnel;
