DTK PAM-0066I, User Manual

Page: 44 / 67

Chapter 4
38
Video Off Method: Choose V/H SYNC+Blank, DPMS or Blank Screen. This is monitor Power
Saving Method. V/H SYNC+Blank means turn off Vertical, Horizontal scanning and blank the
screen. Blank Screen will blank the display screen. DPMS (Display Power Management System)
can allow the System BIOS control the Display Card to turn off the Display.
Video Off After: As the system moves from lesser to greater power-saving modes. Select the
mode in which you want the monitor to blank. The available options are “Standby”, “Suspend”,
“Doze” and “NA”.
MODEM Use IRQ: Available options are 3, 4, 5, 7, 9, 10, 11 and NA. It is used to choose the
interrupt line that the Modem is used. “NA” means not available.
Suspend Mode: To set the time period waiting for Suspend Mode when the Power Management
function is set to “User Define”.
HDD Power Down: To select the time period will turn the HDD off. Accessing the HDD again
will take a few seconds for HDD to spin up for operation.
Suspend Mode Option: Available options are “PowerOn Suspend” and “Suspend to Disk”. For
“PowerOn Suspend” option, the system will enter the suspend mode with the power supply still
switching on. For “Suspend to Disk” option, the system will fully power off the system when it
entering the suspend mode. With installing the Award Zero-Volt Data-Suspend Utility (
ZVHDD ),
the system will resume back when the system power on again.
Throttle Duty Cycle: When the system enters Doze mode, the CPU clock runs only part of the
time. You may select the percent of time that the clock runs. The options are 12.5%, 25%, 37.5%,
50%, 62.5% and 75%.
ZZ Active in Suspend: When Enabled, the ZZ signal is active during Suspend Mode.
VGA Active Monitor: When Enabled, any video activity restarts the global timer for Standby
Mode.
Soft-Off by PWR-BTTN: Available options are “Instant-Off” and “Delay 4 sec.”. For
“Instant-Off” option, the power of the system will be switched off at once when the power button is
pressed for turn it off. For “Delay 4 sec.” option, the power of the system will be switched off with
4 second later after the power button is pressed.
For “Suspend to Disk” feature, this option
should be set to “Delay 4 sec.” Option .
Resume by Ring: When Enabled the external modem ring in can wake up the system. (ATX
power supply required)
IRQ 8 Break Suspend: You can select Enabled or Disabled monitoring of IRQ8 (the Real Time
Clock) so it does not awaken the system from Suspend Mode.
Reload Global Timer Event: When Enabled, an event occurring on each device listed below
restarts the global time for Standby Mode: