12
DoorTec Deutschland | www.doortec.online
04/2022
-
Version 1
Änderungen vorbehalten | Subject to Modifications
Parameter
Value
Forced closing
Only when car wash function is selected (parameter 33), closing even though
photo has not been activated
00 =
No forced closing
01 =
Forced closing after 2 min.
02 =
Forced closing after 5 min.
03 =
Forced closing after 10 min.
04 =
Forced closing after 20 min.
GO function (Step)
Only when photo is selected (parameter 31), Impulse function used for step
-
by
-
step operation
00
Normal go function (Closing is only possible from open limit)
01
Special go function (stop command possible in opening direction)
Automatic closing is normally only allowed if additional photo safety is used
(parameter 31). Auto close without additional photo safety requires a connect-
ing bridge between X3, 20
-
22 (parameter 31:02).
Interlock function
Only when auto close is selected (parameter 32)
00 =
Interlock function OFF
01 =
Interlock function ON
Run time control
00 =
No run time control
01 =
run time 20 sec.
02 =
run time 40 sec.
03 =
Automatic run time.
”
RUN
”
position is now available by pressing STOP.
Run the door from closed to open position without any stop
(keep press OPEN).
When run time is learned (by open limit) the
”
RUN
”
will stop flashing
and the display will automatic switch back to active parameter number).
Run time is learned time + 12.5%. Below 10 seconds learned time,
fixed 1 second is added.
Notice: Both limits must be set before selecting automatic run time.
Reverse time safety edge
xx =
Reverse time of safety edge in 1/100 seconds.
01 =
0,01 Sec
Range: 0.00 –
0.99
sec
(when using a single phase motor the parameter is to be set to 50 to avoid
problems with too fast reversing time)
(If 00 is selected the reverse time is set to minimum 0.004 sec.)
