Rev Date 9/16/2010
12
Install/ Remove Battery Pack
The battery comes with WebDT 435 is shipped partially charged. Before you start using your device, please fully charge the
battery.
Follow the steps below to install the battery pack for your WebDT 435:
1. Removing a Battery Pack
i.
Hold the device with one hand with the front panel turned down.
ii.
Slide the Battery Pack Switch up to release the battery.
iii.
If necessary, lift the battery pack up with the stylus.
iv.
Tilt the battery pack until it disengages from the device.
v.
Slide the battery pack out to remove.
2. Installing a Battery Pack
i.
Align the battery pack’s guide pins at bottom with the two concave indentations inside the battery compartment.
ii.
Push the battery gently into place.
iii.
Move the Battery Pack Switch down to lock the battery pack in place.
iv.
The battery pack is now successfully installed.
Note
The WebDT 435 can only be powered when the Battery Lock is correctly in place.
3. Charging the Battery- There are three ways to charge the WebDT 435 battery.
i.
Charge the WebDT 435 directly by connecting the AC adapter to the DC-in port of the WebDT 435 The Power LED
will be flashing while charging. When the Power LED turns to be steady blue, the battery is fully charged.
ii.
Put WebDT 435 on the desktop charging cradle. The Power LED will be flashing while charging. When the Power
LED turns to be steady blue, the battery is fully charged.
iii.
Put the WebDT 435 battery on the back of the desktop charging cradle to charge the battery.
The battery is fully charged after about 8 hours of charging.
