■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
▼
Connector Pinouts and LEDs
DS1104 Hardware Installation and Configuration March 2004
87
▲
■■■■■■■■■■
I
▲
■
■■■■■■■■■■■■■■
Slave DSP Flash Jumper (J1)
The slave DSP contains an on-chip flash memory. The flash jumper (see
Board Overview
on page 78) is used to set the protection mode of the
flash memory and the slave DSP watchdog mode.
The VCCp pin of the TMS320F240 slave DSP selects the protection
mode of the flash memory and the slave DSP watchdog mode:
■
If the jumper connects VCCp to VCC (default setting):
•
erase/write operations to the flash memory are enabled
•
the watchdog is disabled
■
If the jumper connects VCCp to GND:
•
erase/write operations to the flash memory are disabled
•
the watchdog is enabled
N
The dSPACE software does not support the watchdog of the slave DSP.
For this reason, do not change the jumper’s default setting shown
above.
1
2
3
GND
VCCp
VCC
Summary of Contents for CLP1104
Page 6: ...Contents DS1104 Hardware Installation and Configuration March 2004 I 6 ...
Page 20: ...Safety Precautions DS1104 Hardware Installation and Configuration March 2004 I 20 ...
Page 118: ...Mapping of I O Signals DS1104 Hardware Installation and Configuration March 2004 I 118 ...
Page 162: ...Data Sheets DS1104 Hardware Installation and Configuration March 2004 I 162 ...