27
DESIGNED SECURITY INC
800-272-3555 www.dsigo.com
1402 Hawthorne Street Bastrop, Texas 78602 Fax 512 321 9181 Email: [email protected]
INS-8900-151110
PRESENCE SENSOR ALIGNMENT
When the bollards are aligned, level, and plumb the sensor setting from the factory will be ready-to-go in most
instances. When the beam is aligned correctly the LED will be lit.
If an unlighted Sensor Status LED is found:
Verify the beam path is clear of obstructions.
Examine both Bollards for anything blocking the beam, or misalignment.
Repeat for each Sensor that has the Status LED unlighted.
Once each Presence Sensor status is verified (LED On) the Barriers should cycle and park extended across the
lane on power-up, and/or when Bypass input is cycled. If the Barriers do not move, or, if there is an Alarm
condition, repeat the above steps.
Tailgate Sensors -
Flashing Red LED indicates beam is blocked or not calibrated
Transmitters
- Green LED indicates power on
TAILGATE SENSOR CALIBRATION
1. Install all Sensor covers (Plexiglas must be
in place for calibration)
2. Clear the beam path of obstructions across
lane
3. Use a paper clip or wire to press the CAL
button through the hole in metal below I/O
board
4. Displays will show “DSI” while calibrations
is in process
5. Gates will begin Home routine
6. Display will show “Present Card” when
done.
DIP SWITCH - Factory Default - DO NOT ADJUST
The 2 DIP Switches located near the motor are set at
the factory. These switches must remain set as
shown for turnstile operation. Reference the drawing
at right should the DIP Switch settings be changed.
Summary of Contents for ES8900
