USER MANUAL
SPEED DOME CAMERA SD-Dxxx Series II
Page:
10
Page:
10
WWW.DSE.EU
System PRESET
Not all of the 255 camera presets are available for user customization; some presets,
60-99,
Not all of the 255 camera presets are available for user customization; some presets,
60-99,
They are used by the camera for specific functionality and are denominated SYSTEM PRESET. The system Preset allow access to the configuration of the camera and to impart quickly the main
controls, such as the start of SCAN, and PATTERN CRUISE. Even the control console and provide DVR button to start automatic movements, but often, because of imperfect standardization of
Pelco protocol may not be effective. The use of the system presets is instead always working on each type of control units.
The cameras in this range allows many operations with the use of the OSD menu system presets making even superfluous describe later.
PRESET
FUNCTION CONTROL
DESCRIPTION
GENERAL COMMANDS
60
CALL
Clear Preset
Recalling the preset 60 to delete all the preset settings that were previously stored in the camera.
95
CALL
Opens OSD
Recalling preset 95 opens the general OSD programming menu (see below)
70
CALL
Opens OSD menu only camera module
Recalling the preset 70 opens the programming menu of the OSD only camera module (see below)
96
CALL
Restore default
Restore factory settings
56
CALL
Video format CVBS (SD model only
---- 4)
Switches the camera video output CVBS (Traditional analog). The command is only active on the 4 in 1
(--- 4)
57
CALL
AHD Video format (SD model only
---- 4)
Switch the camera's video output AHD (analog high definition). The command is only active on the 4 in 1
(--- 4)
58
CALL
Video Format CVI (SD model only ----
4)
Switch the camera's video output CVI (Dahua). The command is only active on the 4 in 1 (--- 4)
59
CALL
TVI Video format (SD model only ----
4)
Switch the camera's video output in TVI (Hikvision). The command is only active on the 4 in 1 (--- 4)
SETTING ACTION HOME (HOME)
61
CALL
Set IDLE to PRESET 1 In all our PTZ cameras you can set a
main action, ie a type of movement that the camera will return to run automatically after a certain idle
time of the operator. This main function is defined IDLE. Recalling the 61 presets the leading position of
the camera (IDLE) will be the PRESET 1
62
CALL
Set IDLE on TOUR 1
Recalling the preset 62, the main camera position (IDLE see above) will be the TOUR 1
63
CALL
IDLE SCAN Set of A / B
Recalling the preset 63, the main camera position (IDLE see above) will be the panoramic scanning
between two points A / B switch
64
CALL
Set on IDLE SCAN 360 °
Recalling the preset 64, the main camera position (IDLE see above) will be scanning the panoramic
360 °
70
CALL
Opens OSD room
Recalling the preset 70 opens the menu screen (OSD) for the configuration of the camera module
TOUR MANAGEMENT (CRUISE)
