INSTALLATION MANUAL
DS-N4 - HD-SDI Video
Page:
46
Page:
46
DSE SRL - ITALY - WWW.DSE.EU
remote access
The DS Series DVR can be controlled remotely through a local network or the Internet using PC or mobile devices like mobile phones,
iPhone / iPad, PDA etc.
In order to make these operations you must first correctly configure the DVR to the network.
CONNECTING TO THE NETWORK
To connect the DVR to the network using a LAN cable CAT5 or higher with RJ45 connector, straight type (not crossover). Connect the
LAN port of the DVR to a free switch port. Check that after connecting the green and yellow LED on the DVR connector light up. This
confirms the good functioning of the physical connection.
SETTING THE NETWORK PARAMETERS
To set the essential network parameters to the network operation act in the DVR configuration and subsequently clicking CONFIG
NETWORK as shown above.
IP ADDRESS (IP ADDRESS) - SUBNET MASK - GATEWAY
The first parameter to set is the DVR IP address that identifies the network and allow you to achieve it. All the elements of the network
the first 3 digits of the IP must share it (eg. 192.168.0.XXX) and the subnet mask to be able to share information. Factory DVR uses
DHCP auto configuration that automatically regard by swicth network (or other DHCP server) IP address, subnet mask and gateway
which are the basic communication parameters. If DHCP was disabled should turn it on and restart the DVR to get the network
parameters at startup.
