DSE Model 5210 Automatic Start Engine Management and Instrumentation System Operators Manual
22
057-011 5210 OPERATING MANUAL ISSUE 5.1 18/06/2007 AM
7 FRONT PANEL CONFIGURATION
Although full configuration of the module is possible using the 5200 series configuration software, selected
parameters that may require adjustment in the field are able to be adjusted via the module’s fascia.
7.1 ACCESSING THE FRONT PANEL CONFIGURATION EDITOR
This configuration mode allows the operator limited customising of the way the module operates.
Operation
Detail
To enter the
‘configuration mode’
press both the
CONFIGURE/LOG
and
STOP
buttons together.
+
7.1.1 ENTERING THE CONFIGURATION EDITOR PIN NUMBER
If the module PIN number has been set, the PIN number request is then shown. The configuration cannot be
viewed or changed until the PIN number is correctly entered. If no PIN has been set, then skip to the next section.
Pin
The first - is flashing.
----
Pin
Press + or – buttons to adjust it to the correct value for the first digit of the PIN number.
Press
9
when the first digit is correctly entered.
The value you have entered will ‘disappear’ to maintain security.
1---
Pin
The second - is now flashing. Press + or – buttons to adjust it to the correct value for the second digit
of the PIN number.
Press
9
when the second digit is correctly entered.
----
Pin
The third - is now flashing. Press + or – buttons to adjust it to the correct value for the third digit of the
PIN number.
Press
9
when the third digit is correctly entered.
----
Pin
The fourth - is now flashing. Press + or – buttons to adjust it to the correct value for the fourth digit of
the PIN number. Press
9
when the fourth digit is correctly entered.
----
NOTE: - When
9
is pressed after editing the final PIN digit, the PIN is checked for validity. If the
number is not correct, the editor is automatically exited. To retry you must re-enter the editor as
described above.
If the PIN is entered correctly, The first configurable parameter is then displayed :
The parameter being displayed in this example is the Low Oil
Pressure prealarm, being indicated by the illuminated oil can.
The warning symbol
is indicating that it is the warning (pre-
alarm) parameter that is being displayed.
NOTE:- To exit the front panel configuration editor at any time, press the Stop/Reset
button.
Ensure you have saved any changes you have made by pressing the
9
button first.
CALL US TODAY
1-888-POWER-58
REQUEST A QUOTE
SHOP ONLINE
www.genpowerusa.com
