![background image](http://html.mh-extra.com/html/ds-produkte/04370/04370_manual_2533517025.webp)
25
EN
Use
PLEASE NOTE!!
■
WARNING – Danger of Fire!
!
–
Keep combustible materials away from the device. Furnishings such as upholstered
furniture or curtains should be a minimum of 30 cm away.
–
Do not leave the device unattended, so that you can intervene immediately in the
event of any faults.
■
Some items of furniture have coatings which might affect the rubber feet of the device.
If necessary, a mat should therefore be placed under the device.
■
Do not cover the device during operation. Do not hang any laundry or similar items
over the device to dry.
The device can be used for additional heating as well as for cooling and humidifying the
air. If the device is to be used for cooling, the lamella insert (
7
) must be moistened and
the water tank
fi
lled before use (see the “Moistening the Lamella Insert and Filling the
Water Tank” chapter).
1. Always place the device on a dry,
fl
at, solid, heat and moisture-resistant surface with
clear space of at least 30 cm above it and on all sides.
2. Insert the mains plug into a properly installed socket that is easily accessible.
3. Move the On / Off switch (
12
) to position
I.
The whole of the display (
13
) lights up
brie
fl
y.
The
calibration procedure
for aligning the device then begins. The upper part of
the device rotates to determine its current position and
fi
nally returns to the starting
position. The cold air outlet (
6
) is located at the front, above the control panel (
5
).
During this procedure, the four bars above the
Speed
button (
17
) light up one after
the other. When the
fi
rst bar
fl
ashes, the process is completed and the device is in
standby mode.
4. Press the
Speed
button to switch the device on. The fan begins to operate at Level
1. The 1st bar lights up constantly.
The device is in the pre-set cooling mode (blue bar). Rotation and timer are both
deactivated.
5. Press the
Cold Warm
(
15
) button to switch to the heating mode. The red bar lights
up and the upper part of the device rotates 180° on its own axis until the warm air
outlet (
9
) points forward. The heating process does not start until the upper part has
rotated completely.
When switching from heating to cooling mode, the heating stops and the device
remains in the same position to cool down for about 15 seconds. The upper part
of the device then rotates to the cooling position.
6. If necessary, set the speed level, rotation and timer (see the “Function Overview”
chapter).
PLEASE NOTE:
If you have set the timer, the device automatically switches
to stand-by after the set time elapses.
7. Press the
Speed
button several times to switch off the device.
8. When you have
fi
nished using the device you set the On / Off switch to
O
and pull the
mains plug out of the socket.