EN
24
• The buttons on the control panel and the remote control only work if the device has
been turned on using the On / Off switch (
12
).
PLEASE NOTE:
After the calibration
process (see the “Use” chapter) the device can only be started via the
Speed
button
on the remote control.
• The device is equipped with a safety switch that automatically puts the device into
standby if the device is tilted more than 45° (± 10°).
Before Initial Use
• Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
Never remove the rating plate and any possible warnings!
• Insert batteries into the remote control (see the “Inserting / Changing Batteries in the
Remote Control” chapter).
Inserting / Changing Batteries in the Remote Control
Before inserting the batteries, check whether the contacts in the remote control and on
the batteries are clean, and clean them if necessary.
1. Slide open the battery compartment cover in the direction of the arrow and remove it.
2. Remove the used batteries if necessary and insert two new batteries (1.5 V, AAA type).
Pay attention to the correct polarity (+ / –).
3. Place the battery compartment cover back on the battery compartment and turn it
counter to the direction of the arrow to shut it.
Replace the batteries when the power of the remote control starts to wane.
Moistening the Lamella Insert and Filling the Water Tank
1. Pull the water tank (
1
) up out of the device.
2. Press down the catch of the cold-air cover (
8
) on the inner
edge of the device. The cold-air cover separates from the
housing (
3
).
3. Remove the cold-air cover from the front of the device.
4. Remove the lamella insert (
7
) from the device.
5. Immerse the lamella insert in cold water.
6. Shake off excess water and place the lamella insert back
into the device.
7. Insert the cold-air cover into the housing and press it
fi
rmly
into place at the top. Make sure that the latch is locked into
the corresponding recess. The cold-air cover must engage
audibly.
8. Unscrew the valve at the lower end of the water tank.
9. Fill the water tank with max. 700 ml cold tap water.
10. Tighten the valve of the water tank again.
11. Insert the water tank into the device and press down
slightly. The blades on the water tank must be
fl
ush with
the edge of the housing.