LPV1200 DUO SYSTEM
Page 32 of 40
1) After having placed two rolls of adhesive film into the front and rear brackets, pull the
adhesive films with hands until feeling a certain resistance.
2) Trim the upper and the lower films at the left and the right sides. If there are errors, you
should turn the adjustment collars to move the film roll to either the left or the right.
3) If the requirements are still not be met, please loosen the orientation collars of the mandrel
and fix the film rolls again.
▲
Note: If the adhesive films can’t be tightened, you should turn the
adjustment collars to increase the friction force.
2. Feeding the film (please refer to figure 12):
Turn separately the front and the rear pressure-adjust hand-wheels to lift up the front and
the rear upper rollers. Put the adhesive films at the edge of the operation panel, make the upper
and the lower films straight with proper forces, turn the pressure-adjust hand-wheel to let down
the front and the rear upper rollers and place the front and the rear pressure-adjust hand-wheel at
the lost motion ----that means to turn them to the most loosen status.
Note: due to the thermal inflation arising from the heating process which will change
the pressures, it needs to be adjusted when the roller surface reaches a certain temperature,
that is: place the front and the rear pressure -adjust hand-wheel till lost motion
occurs----that refers to the most loosen status of the hand-wheel.
3. Functions set-up:
1) Press the Cold mounting and Heating button to Heating;
2
)
Press the button of Single/Double to Double;
3
)
Turn the temperature knobs to the temperature applicable for laminating (If the machine
heating is completed, the working indicator will turn from red flicking to green
normally-on).
4
)
Turn the speed knob to the speed you require.
4. Methods for feeding text and drawings: