Fit 4 of the rubber grommets to the dome
as shown.
1
Slot 4 of the desired dome fixing pins through the grommets. There are two holes
milled into the pins to adjust tension.
2
Cut the stainless steel coated wire to around 10cm’s
each and feed on one of the crimps.
3
Fit the wire through the lower center plate
hole looping it back on itself pushing the
end through the crimp.
4
x4
Standard dome pin setup
Extended dome pin setup
Pull the crimp tight making the
loop smaller and use some pliers
to squash it.
Repeat this process on the other end
of the wire and push on a R-clip
OR
x4
x4
46
Summary of Contents for SkyJib 6
