Phantom Aluminium Wheelchair (2022-01 rev2)
Page 4 of 16
Preparing for use
These instructions should be read carefully before using the wheelchair.
This product is not for user assembly and does not have a service manual.
The following parts may be adjusted by approved service personnel to suit
each user’s requirements:
1.
Brake Unit (Transit Models)
Loosen the bolt heads with a 5mm hex key, sliding the brake unit along
the frame. Test both parking and cable
brakes after readjusting.
2.
Armpad Position
Angle the armpads up or down by
holding the buttons on either side, as
shown in the
adjusting armpads
image.
3.
Footrest Height
See the
footrest adjustment
section for
more information.
A risk assessment must also be performed to assess suitability of the device
for the user. This assessment should include, but not be limited to:
• Small adults (and children)
• Users (and attendants) who lack capacity
• Very active occupants
• Unauthorised access to the wheelchair
Independent users and attendants are responsible for determining that they
are both mentally and physically capable of using the wheelchair with
minimal risk of harm.
Maximum occupant mass – Exceeding the limit marked on your
device can damage the product and put users at risk of harm.
Remove all packaging and stand the wheelchair on the ground. Separate the
armrests to open the wheelchair, then push down firmly. Once the seat is
secure, the backrest is upright and the footrests are attached (see overleaf),
the wheelchair is ready for use.
Adjusting
armpads
Summary of Contents for DeVilbiss Healthcare LPHWCSP19SIL
Page 1: ...Phantom Aluminium Wheelchair LPHWCSP19SIL LPHWCTS19SIL Instructions for use ...
Page 12: ...Page 12 of 16 Phantom Aluminium Wheelchair 2022 01 rev2 This page is left blank intentionally ...
Page 13: ...Page 13 of 16 Phantom Aluminium Wheelchair 2022 01 rev2 This page is left blank intentionally ...
Page 14: ...Page 14 of 16 Phantom Aluminium Wheelchair 2022 01 rev2 This page is left blank intentionally ...