assembly instructions
1. Remove contents from box.
2. Place seat upside down on a flat surface so holes
are showing.
3. Align leg section A (the leg section that has the
concave area on the underside) with the holes in
seat. Place and tighten the two handscrews in the
outer holes. Be sure to put on a metal washer and a
plastic washer (in order). Do not affix the middle
handscrew.
4. Align leg section B (the leg section that has the con
cave area on the top side) with the holes in the seat.
Place and tighten the two outer holes using the
handscrews and washers.
5. Place the middle handscrew and tighten through the
two legs.
NOTE: Periodically check the handscrews to make sure
they remain tight as loosening may occur.
A
B
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2005 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
