18
6. BATTERY CHARGING AND CARE
♦
The batteries carry a eight-month of manufacturer's warranty. This warranty only
covers issues relating to manufacturing faults, and not faults relating to failure to
recharge the batteries as instructed above.
&
Suggestion – How to maximize your batteries efficiency and service life
1.
Fully recharge your new battery before its first time use.
2.
Be sure to charge the battery fully every time. The battery life will be seriously
shortened or decayed if the battery is repeatedly used without being fully
charged.
3.
Always complete the charging until the orange LED light turns green. NEVER
stop charging before it is complete.
4.
Keep your batteries fully charged whenever possible.
5.
If you do not use your scooter for a long time, it should be charged at least every
week to keep the battery in a fully usable condition.
6.
The ambient temperature will affect charging time. Charging time will be longer
in the winter.
7.
After charging, do not leave the charger socket plugged in to the scooter, as this
will cause a power drain on the scooter and temporarily reduce its range.
■
Cleaning the battery
If the batteries are contaminated by water, battery acid, dust or other substances, they
will discharge quickly. The batteries supplied with the scooter are sealed and as such
are maintenance free with no risk of battery leakage. Please follow the steps below to
clean the battery.
1.
Turn the scooter power switch to OFF.
2.
Follow the procedure in the next section “Replacing the Batteries”.
3.
Use a clean cloth to wipe off the soiled area.
4.
Take out the battery.
5.
Clean the battery with a clean cloth. If the terminal is covered by white powder, please
wipe it clean using warm water.
6.3
REPLACING BATTERIES
■
Batteries replacement
Follow the procedure below step by step to replace the batteries:
1.
Turn the remove switch to unlock. Then remove the battery pack from the scooter.
2.
Open the battery pack then disconnect the cables from the four battery terminals.
3.
Remove the batteries from the battery pack.
4.
Place new batteries inside the pack.
5.
Connect the red cable to the positive (+) battery terminal and black cable to the
negative(-) on the other battery.
6.
Connect up the fused cable between the two batteries and close the battery pack.
