WARNING
Do not attempt to adjust or operate wheelchair
without reading carefully all instructions in this
manual.
This wheelchair has not been approved as a
seat that can be used within vehicles of any
kind. Always transfer wheelchair user to a
vehicle manufacturers approved seat and use
safety restraints available.
Do not operate this wheelchair on roadways,
streets or any surfaces with vehicular traffic.
Do not attempt to operate on inclines 10% or
greater without proper assistance.
Be sure to completely engage wheel locks
when getting in and out of wheelchair or when
in elevator or wheelchair lift.
Wheelchair should be on a smooth, stable and
level area with wheel locks engaged before
transferring user in or out of wheelchair.
Do not adjust foot rests any lower than 2-1/2”
from floor.
When getting in or out of wheelchair, do not
stand on or apply weight to foot rests.
Before reaching or leaning forward, rotate cast-
ers to front of the wheelchair engage wheel
locks to help prevent wheelchair from tipping
over.
REMOVAL OF SWING-AWAY FOOT RESTS/LEG
RESTS
- Release lock by pushing on the front rigging
lever. Swing-away foot rest /leg rest out and side-
ways. Lift to remove.
ADJUSTING LENGTH OF FOOTREST/LEG REST
-
When adjusting length of foot rests or leg rests, user
should be sitting in wheelchair with feet on the foot
plates. Loosen bolt on the clamp around support
assembly. Raise or lower foot plate to desired posi-
tion that will provide maximum support of thighs.
Front rigging should not be so low that it causes
uncomfortable pressure to thighs at front of seat
upholstery. Footrest should not be lower than 2-1/2”
from the ground to ensure clearance.
ADJUSTING/ELEVATING LEG REST
- Lift foot
plate on leg rest assembly to desired position.
Release leg rest assembly and it will automatically
lock into place. To lower, push out on leg rest lever
and lower foot plate to desired position.
WHEELS
- Large rear wheels should be inspected
at least once a month to ensure proper tightness. If
wheel wobbles or is loose, release lock nut and tight-
en axle bolt slightly. Test for proper tightness by
learning chair to one side and spin adjusted wheel.
GENERAL CARE
- Wipe chrome parts with a clean,
soft cloth at least once a week. All metal parts can
be cleaned with auto wax or similar poducts. If
exposed to moisture, dry immediately. Do not use an
abrasive cleanser that will scratch the finish.
TO OPEN CHAIR
- Open wheelchair by tilting to
one side and pushing down on seat rail until fully
opened.
TO CLOSE/FOLD CHAIR
- First fold foot plates to
vertical position. Grab seat with both hands at front
and back edge and lift. Or, tilt chair to one side and
lift up on seat rail.
REMOVABLE ARMS
- Remove arms by depressing
spring button and lifting arms out of front and rear
sockets.
