Drive Medical Bellavita, Operating Instructions Manual

Page: 13 / 26

Installation and use
English ·
13
W
Operating the Bellavita in the bath
1. Before using your bathlift, make sure that the
hand control is connected properly via the
plug-type connection on the bathlift. The red
ring at the jack is now unseen. Press the ON
button (green) on the hand control. The green
control lamp is illuminated.
2. Now press the UP button (yellow). The back-
rest moves to an upright position first; then
the lift rises to its end position and switches
off automatically. The lift can be raised to any
height in between, by releasing the button
once the required height is achieved.
3. Fold out the side flaps until they rest on the
sides of the bath. Raise the seat until the seat
surface is at the same level as the upper edges
of the bath and the side flaps are in a horizon-
tal position.
¢
Important: The side flaps must rest flat on
the side surfaces of the bathtub.
4. Sit down on bathlift. If this is not possible
without help, ask for assistance.
5. To lower bathlift, press the Down button (blue).
The lift lowers until it reaches its end position,
then the backrest is tilted back automatically.
The drive switches off automatically in the end
position. However, the backrest can be rec-
lined to an angle in between by simply relea-
sing the button once the required angle has
been achieved.
¢
Attention! If the backrest pushes against
the wall of the bath release the blue but-
ton immediately!