Drive DeVilbiss Healthcare 9003, Instructions For Use Manual

Page: 9 / 24

9
The mattress platform can be levelled by pulling a handle found at the foot end of the
cot. There is one lever to activate the foot end and another for the head end, found
to either side of the shelf.
Note: The foot end is signified by the end with the shelf and the head end by the drip
pole sockets.
i) CPR Operation
To operate the mechanical CPR, pull the lever that is applicable to the raised end of
the mattress platform. If the foot end is raised the CPR handle that states ‘CPR – foot’
must be pulled and vice versa for the handle that states ‘CPR – head’.
If there is any doubt as to which handle should be pulled it is advised that
both handles be pulled at the same time.
Note: The CPR function only flattens the mattress platform.
9. EMERGENCY MECHANICAL CPR FUNCTION
(OPTIONAL ACCESSORY)
• When operating the manual CPR function ensure that all limbs/hands
and equipment are clear in order to prevent trapping or injury.
• Ensure the correct handle is pulled, if unsure pull both.
• Following CPR activation, if the system is not reset the mattress
platform will not operate correctly.
ii) Resetting the CPR
Once the CPR has been activated the system must be reset. If it is not reset the
mattress platform will fail to operate correctly. Depending on which end has been
activated the head/foot end tilt down button must be pressed for 25 seconds
to reset the system. If the foot end CPR lever has been pulled, the foot end
down button
must be held down for 25 seconds and if the head end lever is
activated the head end down button should be pressed. When the system
has reset, the handle will drop back to its original position and the mattress
platform is ready for use again.
Warning