DriSteem Vapor-logic3, Installation And Operation Manual

Page: 19 / 84

15
Keypad/display installation.
Installation
Installation:
Keypad/display installation
Installing the keypad/display
IMPORTANT : Do not locate the keypad/display
inside the control cabinet. The hardware is premounted
in the keypad/display case with front access to the
digital display and keypad. Position the case in a
convenient location for easy access.
Note that the keypad/display requires an ambient
temperature range of 0°C to 50°C to operate properly.
Exceeding these limits will result in a poor reading or
no reading at all.
Installing modular cable
IMPORTANT : When routing modular cable inside
the control cabinet, route cable away from all power
wiring and connect the male modular plug into the
VAPOR-LOGIC ®
3
printed circuit board-mounted female
modular receptacle, J2. Push male plug in until you hear
a “click.” (The cable should be plugged into the keypad/
display as well.) The six-wire cable provides the AC
power to the keypad/display and completes the FTT-
10A-type digital communication between the keypad/
display and the VAPOR-LOGIC
3
control board.
CAUTION : If a longer cable is needed, do not
attempted to fabricate one. Improper wiring can
permanently damage the VAPOR-LOGIC
3
board,
keypad or display. Please contact your local
DRI-STEEM representative for longer cable options.
VL3-IOM-0301-METRIC.pdf 19 11/19/2009 9:22:37 AM