19
VAPOR-LOGIC
®
VERSION 6 INSTALLATION AND OPERATION MANUAL
VAPOR-LOGIC KEYPAD/DISPLAY
If your keypad/display is factory-mounted and connected to the Vapor-logic
board, proceed to installing the next device required by your system .
If your keypad/display was shipped loose, mount the keypad/display in a
location so that the provided cable is long enough to connect the keypad/
display to the Vapor-logic board .
To connect a Vapor-logic keypad/display to the Vapor-logic board, insert the
male end of the provided cable into the Vapor-logic board at Terminal P10
(labeled Display) until you hear a click sound (see also the wiring diagram on
the next page) . Plug the other end of the cable into the keypad/display . This
connection provides DC power and communication to the keypad/display .
See Caution at right before routing cable .
If a longer keypad/display cable is needed, order a replacement cable from
DriSteem (see the replacement parts section of this manual), or use a four-
conductor straight-through cable or a six-conductor, crossover, twisted pair
cable connected to an RJ11 jack .
Note required operating conditions listed on Page 3 .
Other than factory-mounted, there are three ways to mount the keypad/
display . See Figure 19-2 .
Terminal P10:
Display
Mount keypad/display back
directly to wall
Mount keypad/display back to
junction box
INSTALLATION
CAUTION
Keypad/display cable
Maximum cable length is 500’ (152 m) .
When routing keypad/display cable,
route cable away from all power
wiring .
Step 1 – Field wiring: Communication connections
FIGURE 19-1: TERMINAL P10
FIGURE 19-2: MOUNTING THE KEYPAD/DISPLAY
