www.petsafe.net
9
KO
EN
6. Once the Pet Fountain is completely disassembled you will have:
4 plastic parts and the motor.
7. Clean the Pet Fountain parts with warm water and soap. You can also put the Pet
Fountain in the top rack of the dishwasher. Remove the pump before placing the
Pet Fountain in the dishwasher. If possible, it is recommended that you turn down
the heat of the water inside the dishwasher.
8. If you have trouble reaching certain spots or getting hard-to-reach corners, try
using a cotton swab or puchase a Drinkwell
*
Cleaning Kit, a 3-Brush Kit.
Pet Fountain Reassembly
1. Replace the Pump into its location between the four (4) 12.7 mm posts on the
right side of the Pet Fountain. Gently push down to engage the suction cups
(
Fig. 8 & 9
).
2. Thread the plug through the opening in the back left corner of the Bowl
(
Fig. 10
). Next, thread the Power Cord along the back of the Pet Fountain to the
Power Cord “Pass-through” (
Fig. 11
). Use this “Pass-through” to keep the Power
Cord from showing.
3. Line up the Filter Housing unit over the Pump and then the Bowl. You will want to
line up the Intake Tube to fit directly into the Pump. Once in place, gently push
down, locking the Filter Housing into place.
Fig. 8
Fig. 9
Fig. 11
Power Cord
“Pass-through”
Opening
Fig. 10
