User manual
GAS IN BUILT OVEN |EUROPA 60 GAS GRILL
9
N. B: Installation according to the statement of consumer To ensure adequate
ventilation, the back panel of the cabinet unit must be removed.
Install the oven so that it rests on two strips of wood is preferable .If the oven rests
on a continuous, flat surface, there must be an opening of at least 45 × 560 mm.
Panel’s adjacent cabinets must be of a heat resistant material.
In particular cabinets veneer exterior must be assembled with adhesives that can
withstand temperatures up to 100.
In compliance with current safety standards, contact with the electrical parts of the
oven should not be possible once it has been installed.
All parts which ensure the safe operation must be removable only with the aid of a
tool. To hold the oven cabinet, open the oven door and attached by inserting screws
4 into the 4 holes on the frame perimeter.
Do not use the oven door to lever the oven into the cabinet. Never use excessive
pressure to the open door.
Ventilation
The appliance can be installed in a ventilated room permanently as specified in the
regulations. The air flow in the room where the appliance is installed must be
sufficient for proper gas combustion and ventilation of the area. The air intakes
protected by screens, must be the right size (see relevant regulations) and located
so that they cannot be even partially obstructed. The kitchen must be kept properly
ventilated to disperse the heat and humidity produced by cooking processes: in
particular, a window should be opened or using a fan.
45mm
．
560
mm
．
