Instructions EF35002 - 08/10
Camflex
®
II 35002 Series Control Valves
LIMIT STOP STD CAMFLEX 6" and 7"
LIMIT STOP STD CAMFLEX 4.5"
.
Figure 9
CAUTION
CAUTION
WARNING
DANGER
This is required to ensure the shaft (19) is shouldered on
the shaft bearing (8) and to ensure free operation of the
valve.
M.
Loosen lever capscrew (49) and slide lever (34) so it will
shoulder against the shaft bearing (8) and tighten capscrew
(49).
Note: if the actuator cylinder (38) has been removed
proceed to step N. If it has not, proceed to Section 11,
Actuator Stem Adjustment.
N.
Determine the desired actuator action and replace actuator
cylinder (38) on the yoke (33) and secure in place with four
capscrews (36) and lockwashers (37).
O.
Proceed to Section 11, Actuator Stem Adjustment.
10.3 Handwheel Reassembly
A.
Place the valve so the position cover (11) is up.
B.
Remove Truac ring (50) and handwheel washer (51) from
the handwheel powerscrew.
C.
Insert handwheel powerscrew with lock (52) in place into
the appropriate hole in the yoke and screw in clockwise.
D.
Replace the washer (51) and Truac ring (50)
E.
Back off handwheel lightly against washer and lock in the
off position with lock (52).
F.
Replace bottom cover (11) by snapping in place.
Note: To use the handwheel, loosen the lock (52) and
turn. The handwheel can be used as a limit stop on the
valve by locking it in any position.
10.4 Limit Stop Reassembly
Two different types of assembly for the limit stop in function of
the actuator size: see Figure 9.
10.5 Valve Body Reassembly (Refer to Figure 16)
Prior to reassembly, the valve body should be thoroughly
cleaned and the seat ring and plug may be lapped as
indicated in Section 9.2. Upon completion of the above,
proceed as follows:
CAUTION
CAUTION
WARNING
DANGER
Lubricants and sealers are required during reassembly.
Figure 15 identifies recommended products for certain
service conditions. Ensure that any lubricant used is
compatible with service conditions.
A.
Apply a small amount of thread lubricant to the seat ring
retainer threads and install seat ring retainer (3) and hand
tighten only.
CAUTION
CAUTION
WARNING
DANGER
Do not tighten the seat ring retainer to torque specification
at this time.
B.
Place valve body (1) on flat surface so that the seat is
down.
C.
Coat lower guide bushing (22) with recommended lubricant
and insert into the body.
Note: Groove in the guide bushing (22) must be
towards the body center. Refer to Figure 10 for correct
assembly sequence. If the shaft (19) is the original
design it may have a circular grove, if so, install the
retaining ring (18).
Figure 10
D.
Coat the upper guide bushing (21) spacer tube (20) and the
shaft splines (plug side) with recommended lubricant.
E.
Insert the spacer tube (20) over the lubricated part of
the shaft.
CAUTION
CAUTION
WARNING
DANGER
When a recessed groove exists in the spacer tube (20),
this spacer tube (20) must be placed on the shaft (19)
so that the shaft shoulder or retaining ring fits into the
recessed groove on one end of the spacer tube (20).
10
