User Manual
Version 1.2
2017-12-10
ConBee
– USB Dongle
www.dresden-elektronik.de
Page 30 of 33
area is likely to cause harmful interference in which case the user will be required to correct
the interference at their own expense (FCC section 15.105).
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
Consult the dealer or an experienced radio/TV technician for help
9.2.
European Union (ETSI)
The ConBee is compliant for use in European Union countries.
Hereby, dresden elektronik ingenieurtechnik gmbh declares that the radio equipment type
ConBee is in compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: www.dresden-elektronik.de
If the USB Dongle is incorporated into a product, the manufacturer must ensure compliance
of the final product to the European harmonized EMC and low-voltage/safety standards. A
Declaration of Conformity must be issued for each of these standards and kept on file as
described in Annex II of the R&TTE Directive.
The manufacturer must maintain a copy of the USB Dongle documentation and ensure the
final product does not exceed the specified power ratings, antenna specifications, and/or
installation requirements as specified in the user manual. If any of these specifications are
exceeded in the final product, a submission must be made to a notified body for compliance
testing to all required standards.
9.3.
Approved antenna list
The USB Dongle has an integrated chip antenna. The design is fully compliant with all
regulations and certified as reference design of the integrated radio module deRFmega256-
23M12 (FCC ID: XVV-MEGA23M12).
Table 12: Approved antenna
Approved antenna(s) for deRFmega256-23M12
Type
Gain
Mount
Order code
Vendor / Supplier
Integrated antenna
2400 to 2483.5 MHz
Chip antenna
+1.3dBi (peak) SMT
2450AT43B100 Johanson Technology
