Switching On and Off
-
Turn the glue pen on by pressing and
holding the On/Off button
4
until the
LED indicator
5
lights up green (Fig.
2).
The LED indicator will flash while the
t o o l i s w a r m i n g u p . W h e n i t i s
continuously lit up green, the glue pen is
ready to use. If the LED indicator flashes
red, battery capacity is lower than 30%
and should be charged.
-
To switch off the glue pen, press the
On/Off button u n t i l t h e L E D
indicator turns off.
P l a c e t h e g l u e p e n
down in a safe place
a f t e r u s e a n d l e t i t c o o l d o w n
completely before packing it away.
The
hot nozzle can cause damage.
The nozzle and glue
will still be hot until
the glue pen cools.
Glue may leak from
the nozzle.
Note:
The glue pen will switch itself off
a u t o m a t i c a l l y a f t e r t e n m i n u t e s o f
inactivity to save energy.
When switching on again, check the LED
indicator: If it briefly lights up red, the
battery needs to be charged.
Gluing
-
Insert the glue stick
8
in the glue
stick opening
6
. Approximately 5”
(12.5cm) in length of the glue stick
will insert into the opening to engage
the feeder. Hold the tool with the tip
pointing down (Fig. 2). This will help
the feeder grab the glue stick
especially with glue sticks shorter
than 5”.
-
After the glue pen heats up, apply
moderate pressure to the feed trigger
3
(Fig. 3). Applying too much
pressure to the feed trigger may
result in unwanted or unexpected
material flow.
-
If the glue stick does not initially
advance, apply slight pressure to the
back of the glue stick to help engage
the feeder. Do not stick any other
objects besides glue sticks into the
glue stick opening.
-
The glue pen may have glue from a
previous glue stick in the feeder.
After heating, press the feed trigger
to help push out any unwanted glue.
Inserting a new glue stick will help
push out the previous glue from the
glue pen.
-
Apply the adhesive to a single side.
-
Press the materials you wish to glue
together against each other for
around 10 to 30 seconds immediately
after applying the adhesive. It is still
possible to correct the bonding
location at this point.
The bond is stable after approx. two
minutes of cooling time.
Operating Instructions
3
Fig. 3
-8-
3
1
2
4
5
8
6
Fig. 2
1605A000E8.qxp_HSGP-01 6/25/20 11:13 AM Page 8
