RADIO GEAR SETUP
►
Our setup and installation guide is based on the use of our 4.3g digital servos (Part DFFA004). We have
included the exact measurements needed to recreate our setup if you choose another brand of servo.
Additionally, we highly recommend using a programmable radio with flaperon mixing.
Note: Have tools accessible throughout assembly. Only glider parts, adhesives, etc are listed in the "Gather Items
Below" section
.
Gather items below:
Transmitter (battery fully charged)
Micro receiver
(4) Servos with 4 skinny servo arms
(Part DFFA005)
(2) Lightweight aileron extensions, 120mm long (Part
DFLB109)
4.8v, 300mAh receiver battery (fully charged)
1.
Gather four skinny servo arms. Place tiny screws in a
safe place.
2.
Using small wire clippers, trim away one side of all
four skinny servo arms as shown.
3.
Trim two servo arms to have only one hole remaining,
as shown (these will be used for the elevator and
rudder servos). For the aileron servos, trim the two
remaining servo arms down to two holes as shown. If
desired, sand or file down the sharp corners.
4.
Attach aileron extensions to two servos.
5.
Turn on transmitter and plug battery into receiver
(observe proper polarity!).
6.
Activate flaperon mixing (consult your radio manual
for details).
7.
Connect all servos to appropriate receiver channels.
Confirm system is bound and servos are responding.
8.
Ensure all trims and sub-trims are centered and set to
zero.
3.