6.
Apply medium instant glue to areas of
right
foam
wing shown in graphic to the right. Glue is
applied to the following locations on
right
wing
only: molded recesses for dihedral braces,
alignment tab recesses, and adjoining wing root
face areas. Avoid applying glue excessively.
7.
Pick up
left
wing with pre-installed dihedral
braces and join with
right
wing by lowering it
into position, allowing dihedral braces and foam
alignment tabs to locate and align. Press wing
joint together. Using your finger, smooth over pre-
applied masking tape to lock wing panels and
dihedral braces in position and contain excess
glue.
8.
Flip wing over and press center joint together as
shown. Ensure wing panels are in proper
alignment and hold for 15-20 seconds. While
supporting wing carefully, inspect entire center
wing joint. Continue to apply pressure to center
wing joint ensuring a tight joint and good
adhesion.
9.
As shown in the sequence below, apply medium
instant glue to molded recess for Wing Center
Plate. Apply glue to flat area of recess as well as
deeper perimeter channel. Lay one wing half flat
against table while supporting the raised wing
with one hand to maintain dihedral. Now firmly
press Wing Center Plate in place, applying
pressure for 15-20 seconds as shown.
7.