Time
will control the delay time in its whole
range - that is if depth knob is at 0%. As you add
depth, time knob will have a shorter effect. When
100% depth is there, time knob does nothing. Delay
time can be set from 2.5ms up to 50ms.
DEPTH
this indicates the amount of LFO
applied to the Delay time. As you turn up the knob,
the time control will have a smaller range. And
when it’s at max, time control has no effect. In order
to access the “Comb” Filter, keep this control at 0%.
RATE
sets the speed of the LFO, from 10Hz up
to 15sec. When on Stereo setup, each channel has
a reverse movement, which gives the feeling that
the LFO rate is half than the set one.
feedback
this sets the delay feedback. Be
careful as some volume boost is taking place as
you go on high feedbacks , so take care not to peak
the next effects in the order.
Difference between Chorus and Flanger
Both Chorus and Flanger are actually the same
effect: A Delay that its time is modulated by an LFO.
To achieve the Flanger effect you will need Delay
times up to 10ms. When the Delay time is set
between 10ms and 30ms, then the effect you will
hear is the Chorus. Traditionally, a Flanger effect
needs its LFO Rate to be between 1 and15sec,
while a Chorus should be between 250ms and
2sec. Also, when you try to emulate the Flanger
effect you need a decent amount of Feedback.
Chorus doesn’t really care about Feedback, but
usually the best results can be achieved with a
pinch of Feedback.
So what happens without the LFO?
The above delay times can create the “Comb” Filter
effect if no LFO is applied to the delay time. But you
need to have a very high amount of Feedback.
Now, by knowing all the above, you can go through
the controls of Hypnosis Chorus-Flanger.
Press and hold the CHO-FLA button for 1 sec.
The 3 buttons will start to blink.
Choose your desired LFO wave.
After you set the LFO wave, you will
get back to the previous state.
SINE
TRIANGLE
RANDOM
Summary of Contents for Hypnosis
Page 1: ......
