5
THIS TIME CHART IS APPROXIMATE FOR DR. BROWN’S™ VESSEL SIZES.
WARMING TIMES WILL
VARY DEPENDING ON THE VESSEL MATERIAL, SHAPE AND VOLUME. TEMPERED GLASS HAS
BEEN TESTED FOR USE IN THIS WARMER.
CAUTION: NEVER FREEZE GLASS CONTAINERS, AS GLASS MAY BREAK.
WARMING TIME CHART (continued)
CLEANING THE WARMER
CAUTION: Always unplug the appliance and ensure it is cool before cleaning any
part. DO NOT SUBMERGE BASE IN WATER.
Daily
1. Allow unit to cool before cleaning.
2. Remove the top warming chamber from the base.
3. Empty the water from the base.
4. Rinse warming base, warming chamber, and warming basket with clean water.
If storing unit for longer than a day, dry or allow to air dry before re-assembly.
Note: Use of tap water may cause “H20ERR” and can shorten the life of the appliance.
Use distilled water.
Special Cleaning
If the unit warming chamber and/or warmer base becomes contaminated with milk:
Hand wash with clean water and mild detergent.
Note: DO NOT use scouring pads, abrasives, bleach or solvents for cleaning. DO NOT
disassemble base. There are no serviceable parts inside.
1
2
3
4
TROUBLESHOOTING
If the warmer is not operating, check that:
1. The power cable is connected to the power outlet.
2. The water is filled to the proper level.
3. The unit is correctly assembled.
4. If display shows the error “H20ERR,” the warmer may have no/low water condition.
Unplug from power. Fill water to the correct level, to the line ABOVE the “FILL” text.
Reconnect to power.
5. If display shows “H20ERR” message and is properly filled with water, milk/minerals
have come in contact with the heating element and the unit must be cleaned.
Follow the SPECIAL CLEANING instructions.
6. Water overflowing from the warming chamber: This can occur if the bottle has a very
large diameter, such as with a wide-neck glass bottle with silicone sleeve. Remove
the basket and warm bottle directly in the warming chamber.
1
2
3
4
5
6
Summary of Contents for natural flow MilkSPA AC143
Page 20: ...WSP001...
