- 5 -
INTRODUCTION
Water heater with an AQUA HP air
-
water heat pump certainly fulfils all your expectations, and will
comfortably serve you and achieve maximum energy savings for many years. The manufacturer devotes a lot
of time, energy and financial resources to the development of innovations that will promote energy savings
achieved by using the product. Your choice proved correct sentiment and
concern about energy
consumption, therefore,
a matter that affects the environment. The manufacturer has been committed
to constantly come up with innovative and effective products so that the rational use of energy could actively
contribute to environmental protection and natural resources of the planet. This manual, the purpose of
which is to inform, warn and advise in connection with the use and maintenance of this appliance, should be
retained.
1.1
INFORMATION PRIOR TO THE INSTALLATION
The electrical installation must comply with the valid national legislation applicable to electrical
installations.
AQUA HP will work only after adding the correct dose of coolant.
The maximum recommended pressure of water supplied into the hydraulic circuit is 0.3 MPa,
and the minimum pressure is 0.1 MPa.
Power is AC 230 V, 50 Hz and the power cord must be connected to a grounded receptacle.
If the power cord is damaged, it must be replaced by the manufacturer or a trained service
technician in order to prevent any risk.
AQUA HP
shall only be operated if the water heater is filled with water.
Heating other than potable water is not allowed.
1.2
SAFETY INFORMATION
The appliance can be used by children from 8 years of age,
persons with physical, sensory
or mental disability or people without experience or knowledge, as long as those people were
briefed on the operation of this device in a secure manner, and are familiar with the related
dangers.
The appliance cannot be played with by children.
Cleaning and maintenance must not be performed by children without proper supervision
