Draytek VIGOR2820 series, User Manual, Page: 196 / 269

Vigor2820 Series User’s Guide 188
Call Control Setup Dial Retry - It specifies the dial retry counts per triggered
packet. A triggered packet is the packet whose destination is
outside the local network. The default setting is no dial retry.
If set to 5, for each triggered packet, the router will dial 5
times until it is connected to the ISP or remote access router.
Dial Delay Interval - It specifies the interval between dialup
retries. By default, the interval is 0 second.
Remote Activation – It can help users who would like to
access the server which is off the Internet in the head office.
To remotely make the server to be available on the Internet, i.e.
make the router in the head office activating its Internet access
either by dialing-up or starting broadband connection, users
can make a regular phone call (the number is set in the
Remote Activation field) to the router as signaling it for
activation. The phone call will be soon disconnected once the
router is on line.
Note that Dialing to a Single ISP should be pre-configured
properly.
Basic Setup Link Type - Because ISDN has two B channels (64Kbps/per
channel), you can specify whether you would like to have
single B channel, two B channels or BOD (Bandwidth on
Demand). Four options are available: Link Disable, Dialup
64Kbps, Dialup 128Kbps, Dialup BOD.
PPP Authentication - It specifies the PPP authentication
method for PPP/MP connections. Normally you can set it to
PAP/CHAP for better compatibility.
TCP Header Compression - VJ Compression : It is used for
TCP/IP protocol header compression. Normally it is set to Yes
to improve bandwidth utilization.
Idle Timeout - Because our IDSN link type is Dial On
Demand , the connection will be initiated only when needed.