- 6 -
- 7 -
The battery charge LED indicator
will flash, charge for 4 hours or until the charging
all LEDs illuminates.
8. ASSEMBLING THE INSPECTION LAMP
Warning:
Do not connect the machine to the power supply before
the product is completely assembled.
8.2 CHARGING
NOTE: The micro USB connector is tapered and will only go in one way, do not force the
micro USB connector into the lamp; as it may damage the connector or short circuit the
lamp, this may invalidate your guarantee.
Connect the charging micro USB cable
into the charging socket
, which is located on the
rear of the inspection lamp, this is protected by a dust cap which may need to be removed to gain
access to the connector. Connect the 230V charger or 12V DC charger to a power supply and turn
it on.
Disconnect the charger from the inspection lamp when it is fully charged.
Lithium-ion cells prefer small charges often.
Lithium-ion technology is lightweight and compact due to increased capacity in comparison to
other battery chemistries.
Lithium-ion cells have no ‘memory effect’ and a long cycle life with outstanding discharge
performance.
Lithium-ion cells suffer from a loss in capacity or thermal runaway if over charged and will degrade
if allowed to enter deep discharge, however all of these situations are negated due to the complex
circuitry incorporated within this product.
Charging must be carried out in an environment with an ambient air temperature between 5°C to
45°C with the transformer supplied.
To prevent overheating, do not cover the transformer.
Attention:
If the cable is damaged or the non-self-resetting protective device is activated due to
short circuit/overload the transformer shall be scrapped. A replacement of identical specification,
design and application shall be obtained.
Note:
Charging the unit with the 12V DC
charger via a vehicle socket will drain the
vehicle’s battery unless the engine is
running.
The table below highlights the approximate
hours of continuous usage available when
fully charged:
8.1 POWER SUPPLY
Before you connect the equipment to the power supply make sure that the data on the rating plate
is identical to the supply voltage.
Warning!
Always pull out the power plug before making adjustments to the equipment.
6. TECHNICAL
DESCRIPTION
7. UNPACKING
AND
CHECKING
7.1 PACKAGING
Carefully remove the inspection lamp from the packaging and examine it for any sign of damage
that may have happened during shipping. If any part are damaged or missing; please contact the
Draper Helpline (the telephone number appears on the Title page) and do not attempt to use the
lamp.
Warning!
Some of the packaging materials used may be harmful to children. Do not leave any of
these materials in the reach of children.
If any of the packaging is to be thrown away, make sure they are disposed of correctly; according
to local regulations.
7.2 WHAT´S IN THE BOX?
As well as the inspection lamp; there are several parts not fitted or attached to it.
6.1 IDENTIFICATION
UV LED inspection lamp.
3W COB LED inspection
lamp.
Hook.
Magnetic base.
180° Pivoting head.
On/off switch.
Power indicator.
Micro USB charging input
with sliding cover.
Micro USB cable.
USB charger.
High:
3 hours
