LEFT
-HAND
TOP
RIGHT
-HAND
TOP
LEFT
-HAND
TOP
RIGHT
-HAND
TOP
110-220V AC
MOTORIZED OPERATOR
MOUNTING ENDCAPS
ENDCAP
COVER
SNAP-O
N
SNAP-O
N
ENDCAP
COVER
SNA
P-ON
SNA
P-ON
Retainer Clip
Retainer Clip
STEP 2
Clicks into place
STEP 1
Section 1 -
Mounting Endcaps
(Brackets)
Figure 1
Figure 2
Figure 3
Figure 4
Operator End
Idler End
Section 2 -
Installing Fascia
Please Note:
Installer is responsible for selecting mounting hardware
appropriate for site conditions.
1.
Snap endcap covers onto endcaps. The proper orientation of
Left-Hand,
Right-Hand, Front and Back
is molded into endcap covers
(Fig. 1)
.
2.
Mark wall, jamb, or ceiling for placement of mounting endcaps.
3.
Drill small starter hole
(if necessary)
in mounting surface.
4.
Mount endcaps using appropriate fasteners for surface.
5.
Place operator
(motor)
end of
rear
shade into its endcap
(Fig. 2)
.
6.
Secure motor plate with the provided clips
(Fig. 2)
.
7.
Slide notched pin into idler endcap. Secure with retainer clip and lock into
place with rotating idler lock.
(Fig. 3)
8.
Use cord strap to secure electrical cord to endcap. This will prevent the
electrical cord from getting caught on the roller and causing damage to
the shade.
9.
Repeat with
front
shade.
1.
Place groove along top of fascia over end caps, and
snap into place
(Fig. 4)
.
Fascia is not fully seated until
it clicks into place on both ends.
2. Once in place, check for secure fit. If not secure,
secure with appropriate fastener
(not included)
.
PLEASE NOTE: Refer to appropriate
sections within this document
for different installation options:
SECTION 3:
Surface
Headbox Installation
SECTION 4:
Pocket Headbox Installation
page 3 of 10
Dual Roller Motorized FlexShade
®
(Standard Hardware)
