Section 5 -
Attaching Fascia to Endcaps
1.
Place groove along top of fascia over endcaps, and snap into place
(Fig. 5)
.
Endcaps must be installed the correct distance apart for fascia to be properly attached
with full engagement. Fascia is not fully seated until it clicks into place on both ends.
Once in place, check for secure fit. If not secure, use an appropriate fastener
(not included)
.
Reverse Roll Fascia
1.
Slide endcaps into extrusions.
2.
Using provided holes in endcaps, mark the fascia for drilling.
3.
Attach endcaps to fascia.
4.
Mount Endcaps/Reverse Roll Fascia.
5.
Install roller/fabric/operator assembly according to relevant instructions.
6.
Attach endcap covers to endcaps. Use double-sided tape to help secure in place.
Figure 6
ATTACHING CLOSURE PANEL
Figure 7
STEP 1:
STEP 2:
Clicks into place
Fascia Attachment
Small & Large Endcaps
ENDCAP
ENDCAP
ENDCAP
ENDCAP
Figure 5
ATTACHING FASCIA
Section 6 -
Surface Headbox or Pocket Headbox
1. Snap endcap covers onto endcaps.
(See Section 4.2 - Attaching Fascia to Endcaps Step 1)
.
2. Slide endcaps into the top/back portion of surface headbox or into pocket extrusion
of large pocket headbox. Using provided holes in endcaps, mark headbox for drilling.
Please Note:
The installer is responsible for selecting mounting hardware appropriate for site
conditions.
Caution:
Before mounting shades, verify measurements on the provided with
shade,
and ensure endcaps are installed at correct width.
3. Drill holes in back
(wall mount)
or top
(ceiling mount)
, of or in a pocket.
4. Attach endcaps and Surface Headbox back/top or Large Pocket Headbox extrusion to wall,
ceiling or pocket using mounting hardware appropriate for site conditions.
5. Install shade
(See Section 4.1 - Mounting Endcaps for Fascia)
.
6. Attach headbox fascia or pocket closure
(Fig. 7)
.
Note on surface style headbox:
Fascia is not fully seated until it clicks into place on both ends. Once in place,
check for secure fit. If not secure, use an appropriate fastener
(not included)
Large Pocket Headbox
STEP 1
STEP 2
STEP 3
Secure to Endcap
with Screw
Small Pocket Headbox
STEP 1
STEP 2
STEP 3
page 5 of 10
Motorized FlexShade
®
(Coupled)
