Section 1 -
Mounting Endcaps
(Brackets)
Caution:
Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note:
Installer is responsible for selecting mounting hardware appropriate for site conditions.
1.
Snap endcap covers onto endcaps. Proper orientation of Left-Hand,
Right-Hand, Front and Back, is noted on endcap covers
(Fig. 1-A)
.
2.
Mark wall, jamb, or ceiling for placement of mounting endcaps.
3.
Drill small starter hole
(if necessary)
in mounting surface.
4.
Mount endcaps using appropriate fasteners for surface.
5.
Place rear shade spring-loaded pin in idler endcap. Depress spring-
loaded pin by pressing shade roller toward endcap.
Slip operator end of rear shade into slots on endcap
(Fig. 1-B)
.
6.
Repeat with front shade.
Please Note:
Endcaps MUST BE fastened securely to mounting
surface and cannot move from side to side.
LEF
T -HAND
TOP
RIGH
T -HAND
TOP
LEF
T-HAND
TOP
RIGH
T-HAND
TOP
BEAD CHAIN
CLUTCH-OPERATOR
ENDCAPS
ENDCAP
COVER
SNAP-O
N
OP
OP
SNAP
-ON
ENDCAP
COVER
SNA
P-O
N
L
SNA
P-O
N
Figure 1-B
Figure 1-A
IDL
ER
END
CAP
CLUT
CH E
NDCA
P
PLEASE READ -
Important Installation Information
Caution:
1.
Inspect all boxes to make sure
you have received the proper
shades and parts. Controls
may be shipped separately, or
in same carton as shades.
2.
Open cartons lengthwise.
3.
Before mounting shades, verify measurements
on label provided with shade, and ensure unit is
installed at correct width.
4.
All endcaps, fascia, pocket headbox, and other
hardware must be installed level. Shades must
be level and square.
6. Read the following installation guidelines
thoroughly and follow them carefully. Failure
to do so may cause product to fall or otherwise
fail, and invalidates warranty.
7. Installer is responsible for selecting mounting
hardware appropriate for site conditions.
page 3 of 8
Dual Roller Clutch-Operated FlexShade
®
