page 6 of 8
Dual Roller Clutch-Operated FlexShade
®
Slide
Safety
Screws
(RETAIN FOR
LATER)
(RETAIN FOR
LATER)
Section 4 -
Spring Assist Installation
(Optional)
1.
Remove the safety
screw and slide
from the top idler
endcap.
Retain for later.
Caution:
The retaining clip must be installed around
the idler-end shaft as shown to prevent the roller
assembly from moving left or right during operation,
and to ensure that the spring-loaded shaft does not
retract into the mechanism in case of a bearing failure.
3.
Swing the idler end into place, then slide the idler
end spear into the receiver. It may be necessary
to compress the spring-loaded spear.
Caution:
Spring-assist will not operate correctly if installer attempts to change operator location or roll direction.
Do not allow shade roller to become exposed by running shade fabric too far down. Use stop balls provided in hardware
packet by Draper
®
to set up and down travel limits. Stop balls by others may be too small, and become lodged in clutch
mechanism.
Please Note:
If shade fabric is
uneven, see “Field Adjustments”
on page 2.
Figure 4-A
Figure 4-B
Note: Retainer Clip
has extrusion to fit
into slots on shaft.
ROLL
ER
ASSE
MBL
Y
(IDLE
R
/
SPEA
R EN
D)
Rol
ler A
ssem
bly
(IDL
ER/S
PEA
R EN
D)
2.
Use 1/8"
(3mm)
bit to drill
pilot hole through one
of two
(2)
indents near
bottom of Clutch.
4.
Slip notches on operator end into the
endcap, then press down to lock in place.
Figure 4-C
Figure 4-D
