Section 4 -
Endcaps with Fascia
Section 4.1 - Attaching Fascia to Endcaps
1.
Place groove along top of fascia over endcaps, and snap into place
(see Fig. 8)
.
Endcaps must be installed the correct distance apart for fascia to be properly attached
with full engagement. Fascia is not fully seated until it clicks into place on both ends.
Once in place, check for secure fit. If not secure, secure with appropriate fastener
(not included)
.
Section 4.2 - Reverse Roll Fascia
(see Fig. 9)
1.
Slide endcaps into extrusions.
2.
Using provided holes in endcaps, mark the fascia for drilling.
3.
Attach endcaps to fascia.
4.
Mount Endcaps/Reverse Roll Fascia.
5.
Install roller/fabric/operator assembly according to relevant instructions.
6.
Attach endcap covers to endcaps. Use double-sided tape to help secure in place.
Section 5 -
Surface Headbox or Pocket Headbox
1.
Snap endcap covers onto endcaps.
2.
Slide endcaps into the top/back portion of surface headbox or into pocket extrusion of headbox.
Using provided holes in endcaps, mark headbox for drilling.
Please Note:
The installer is responsible for selecting mounting hardware appropriate for site conditions.
Caution:
Before mounting shades, verify measurements on the provided with shade,
and ensure endcaps are installed at correct width.
3.
Drill holes in back
(wall mount)
or top
(ceiling mount)
.
4.
Attach Surface or Pocket Headbox extrusion to wall, ceiling or pocket using mounting hardware
appropriate for site conditions.
5.
Install shade
(See Section 2 - Bead Chain Clutch Installation - Endcaps)
.
6.
Attach headbox fascia or pocket closure
(see Fig. 10)
.
Note on surface style headbox:
Fascia is not fully seated until it clicks into place on both ends. Once in place,
check for secure fit. If not secure, secure with appropriate fastener
(not included)
.
Figure 9
Large Pocket Headbox
Secure to Endcap
with Screw
Small Pocket Headbox
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Large Pocket Headbox
Secure to Endcap
with Screw
Small Pocket Headbox
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
ATTACHING CLOSURE PANEL
Figure 10
STEP 1:
STEP 2:
Clicks into place
Fascia Attachment
Small & Large Endcaps
ENDCAP
ENDCAP
Figure 8
ATTACHING FASCIA
page 6 of 7
Clutch Operated FlexShade
®
Window shade with smooth, quiet operation, and independent control
