Section 2.1 - 24# Clutches
(see Fig. 6)
1.
Mark wall, jamb or ceiling for placement of mounting endcaps and drill small starter hole in surface.
2.
Install clutch onto spear on operator endcap. Slide notched pin into idler endcap. Replace retainer clip
3.
Route bead chain through chain guide, then attach cover using provided screw.
4.
If installing Fascia,
(see Section 4.1 - Attaching Fascia to Endcaps)
. If not, snap on Endcap Covers.
Caution:
Be sure retainer clip installed on roller with 24 lb clutch.
DO NOT use 24 lb. clutch wall brackets on ceiling installations.
DO NOT use 24 lb. clutch ceiling brackets for wall installations.
24 lb. Clutches are LEFT and RIGHT specific.
Section 2 -
Bead Chain Clutch Installation
(Endcaps)
Section 2.1 - 20# Clutches
1.
Mark wall, jamb or ceiling for placement of mounting endcaps and drill small starter hole
(if necessary)
in mounting surface.
2.
Place spring-loaded pin into idler endcap, slip notches on clutch into clutch endcap.
Press down to lock in place
(Fig. 5)
.
3.
Route bead chain through chain guide, then attach cover using provided screw.
4.
If installing Fascia,
(see Section 4.1 - Attaching Fascia to Endcaps)
. If not, snap on Endcap Covers.
Small
3¾" x 3¼"
(96 x 83mm)
2 ¼”
(
57
mm)
3 ¾”
(
96
mm)
2”
(
51
mm)
3 ¼”
(
83
mm)
Large
4½" x 4½"
(114 x 114mm)
3 ¼”
(
83
mm)
4 ½”
(
114
mm)
11
/
16
”
(
17
mm)
11
/
16
”
(
17
mm)
2 ¾”
(
70
mm)
4 ½”
(
114
mm)
Endcaps - 24# Clutch Installation
Idler
Endcap
Idler
Endcap
Idler End
of Roller
Retainer Clip
Clutch
Endcap
45°
24 lb Clutch
Figure 6
Endcaps - 20# Clutch Installation
Idler
Endcap
Idler End
of Roller
Retainer Clip
Figure 5
Clutch
Endcap
10 lb Clutch
page 4 of 7
Clutch Operated FlexShade
®
Window shade with smooth, quiet operation, and independent control
