Section 3 -
Spring Assist
(see Fig. 7)
Caution:
Spring-assist will not operate correctly if installer attempts to change operator location or roll direction.
1.
Remove Safety Screw from idler endcap. Then remove slide
(keep for later)
.
2.
Slip notches on operator end into other endcap, then press down to lock in place. Swing idler end into place. Slide idler end spear into receiver.
If needed, compress spring-loaded spear.
3.
Replace Slide and Safety Screw. Place into groove at an angle, slide up, and make sure bottom of slide hooks into Receiver.
4.
Spear Retaining Clip must be installed around idler-end shaft
(Fig. x)
to immobilize roller assembly during operation.
5.
Route bead chain through chain guide, then attach cover using provided screw.
6.
If installing Fascia,
(see Section 4.1 - Attaching Fascia to Endcaps)
. If not, snap on Endcap Covers.
Caution:
Be sure to lock chain guide cover to chain guide with provided screw.
Please Note:
Make sure 24 lb clutch operator installs to endcap angled toward wall. If shade fabric is uneven, see “Field Adjustments”
(Pg. 2)
.
4
Replace
Slide & Screw
20lb Clutch
Clutch
Endcap
2
Then
Remove
Slide
1
First
Remove
Screw
Idler
Endcap
3
Retainer
Clip
Insert
Spear
Idler
Endcap
Snap On
Endcap Covers
6
5
Clutch
Endcap
Route Bead Chain
Through
Chain Guide and
Attach Cover
Idler
Endcap
Figure 7
page 5 of 7
Clutch Operated FlexShade
®
Window shade with smooth, quiet operation, and independent control
