– 13 –
9. OPERATING THE HEATER
9.1 STARTING HEATER – FIG.3
− Follow all ventilation and safety information.
− Locate heater to provide maximum circulation
of the heated air. Follow all location
requirements noted in Safety Information on
page 6.
− Fill fuel tank with #1#2 diesel/fuel oil until fuel
gauge points to “F”.
− Attach fuel cap.
− Power supply. If using an extension cord, it
MUST be suitable for the heater. Check with
extension cord manufacturer if in doubt to
confirm application.
− For heater with ON/OFF
(1)
switch, push
switch to ON(|) position and heater should start
in 5 seconds.
NOTE: If the heater still does not start, push Power
Switch to “OFF”, then back to “ON”. If heater still
does not fire, see Troubleshooting Guide
NOTE: The electrical components of this heater
are protected by a fuse mounted in the PC board.
If the heater fails to fire, check this fuse first, and
replace if necessary. Also check the power source
to be sure that the proper voltage is being provided
to the heater.
9.2 TO STOP HEATER – FIG.3
Simply turn the Power switch to “OFF” position and
unplug the Power Cord.
9.3 TO RESTART THE HEATER
− Wait ten seconds after shutting off heater.
− Turn the Power Switch to “ON” position.
− Be sure to follow all starting procedure
precautions.
3
FIG.
(1)
Summary of Contents for 04174
Page 18: ...11 MAINTENANCE 11 10 WIRING DIAGRAM FIG 16 18 ...
Page 22: ... 22 ...
Page 23: ... 23 ...